Zodiac JEP-R User Manual

WARNING
H0412200 Rev F
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and
qualified in pool equipment by the jurisdiction in which the product will be installed where such state
or local requirements exist. The maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this manual can be followed
exactly. Before installing this product, read and follow all warning notices and instructions that accompany
this product. Failure to follow warning notices and instructions may result in property damage, personal
injury, or death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can cause serious
injury, property damage, or death.
INSTALLATION AND
OPERATION MANUAL
ENGLISH
|
FRANÇAIS | ESPAÑOL
For use with Jandy Pro Series Variable-Speed Pumps
For Indoor or Outdoor Installations
JEP-R
Variable-Speed Pump
Digital Controller

Zodiac JEP-R Specifications

General

Brand	Zodiac
Model	JEP-R
Category	Network Router
Language	English

Summary

Important Safety Instructions

General Safety Precautions

Follow all electrical and safety precautions for safe operation and to prevent injury.

Pool Pump Suction Entrapment Prevention Guidelines

Guidelines to prevent suction entrapment hazards, ensuring safe pool and spa operation.

Installation of the Digital Controller

Introduction and Controller Panel Overview

Provides general instructions for installing the digital controller and describes the controller panel.

Controller Components and Additional Materials

Lists the components included in the controller assembly and additional required materials for installation.

Backplate Installation Procedures

Details steps for mounting the controller backplate onto an electrical box or a flat wall.

Connecting to Jandy Pro Series Pump and Switch Settings

Guides for connecting the controller to the variable-speed pump and setting pump switch configurations.

Remote Contact Connections and Operation

Instructions for connecting remote contacts, understanding remote operation, and specific behaviors for remote closure 4.

User Operation of the Variable-Speed Controller

Controller Interface and Basic Operation Modes

Explains the controller interface, user mode, and setup mode functionalities.

Manual Pump Control and Speed Settings

Instructions for manually starting, stopping, and setting pump speeds using the controller.

Timeclock Programming and Keypad Lock

Guide for setting up timed pump programs and locking/unlocking the controller keypad.

Service Setup Options

Entering Service Setup Mode

Steps to access the service setup menu for advanced configuration and diagnostics.

Minimum and Maximum Pump Speeds

Setting global minimum and maximum speed limits for the variable-speed pump.

Load Defaults and Last Fault History

Restoring factory defaults and viewing the most recent fault messages.

Priming Speed and Duration Configuration

Configuring the initial priming speed and duration for the pump.

Freeze Protection and Pump Type Settings

Enabling freeze protection and selecting the correct pump type for optimal operation.

eStar Speed and Display Power Usage

Setting the energy-efficient eStar speed and enabling the power usage display feature.

User Set Up Options

Time-of-Day and Speed Label Customization

Adjusting the controller's clock and personalizing pump speed names.

Display Light and Language Settings

Adjusting display backlight and selecting the preferred interface language.

Run Duration and Password Protection Management

Programming specific run durations and managing password access to menus.