To Next PageTo Next PageWhat to do if Zodiac Swimming Pool Vacuum does not move on start-up?
If your Zodiac Swimming Pool Vacuum is not moving upon starting, verify that the control box's power socket is receiving power. Also, ensure that a cleaning cycle has been initiated and the lights are illuminated.
What to do if the control box does not respond to any button presses on my Zodiac Vortex EC11 Swimming Pool Vacuum?
If the Zodiac Swimming Pool Vacuum control box isn't responding, unplug the power cord from the mains, wait 10 seconds, and then plug it back in.
How to fix Zodiac Vortex EC11 Swimming Pool Vacuum that is not correctly cleaning the entire pool?
If your Zodiac Swimming Pool Vacuum only cleans part of the pool, try repeating the immersion steps, and experiment with different immersion locations until you find the optimal spot in the pool.
Why does the cable get tangled on my Zodiac Vortex EC11 Swimming Pool Vacuum?
If your Zodiac Swimming Pool Vacuum cable gets tangled, avoid unrolling the entire cable length into the pool. Instead, place only the necessary cable length in the pool and spread the remainder along the pool's edge.
Why my Zodiac Vortex EC11 Swimming Pool Vacuum does not stay firmly on the pool bottom?
If the Zodiac Swimming Pool Vacuum does not stay firmly on the pool bottom, it might be due to air trapped inside. Repeat the immersion process to remove any air. Alternatively, the filter might be full or dirty, requiring cleaning or replacement. If the propeller is damaged, contact your retailer.
What to do if my Zodiac Vortex EC11 Swimming Pool Vacuum no longer climbs the pool walls?
If the Zodiac Swimming Pool Vacuum is not climbing the pool walls as effectively as before, the filter may be full or clogged, requiring cleaning or replacement. Microscopic algae may also be present, necessitating shock chlorination and a slight reduction in pH. Remember to remove the appliance during shock treatment. Additionally, inspect the brushes for wear and replace them if needed, checking their rotation as well.
What does the message on the screen mean when the remote control mode is active on my Zodiac Vortex EC11 Swimming Pool Vacuum?
If the screen displays a message when the remote control mode is active on your Zodiac Swimming Pool Vacuum, it indicates that the remote control batteries are low and need replacement.
What to do if the remote control LED is steadily lit on my Zodiac Vortex EC11 Swimming Pool Vacuum?
If the remote control LED is steadily lit on your Zodiac Swimming Pool Vacuum, repeat the synchronisation steps to fix the synchronisation problem.
Why does my Zodiac Swimming Pool Vacuum climb walls slowly or too quickly?
The cleaner may behave differently depending on the lining of the pool. A parameter change may be needed; contact your retailer for assistance.
What does error code Er: 10 mean on my Zodiac Vortex EC11 Swimming Pool Vacuum?
If you see error code Er: 10 on your Zodiac Swimming Pool Vacuum, ensure the cleaner is properly connected to the control box. If necessary, disconnect and reconnect it following the correct procedure.
General| Type | Robotic |
|---|---|
| Pool Type | In-ground |
| Power Supply | 24V DC |
| Warranty | 2 years |
| Pool Surface | Concrete, Vinyl, Fiberglass |
| Filter Type | Fine filter |
| Cleaning Time | 2.5 hours |
| Cleaning Coverage | Floor, walls, and waterline |
