EasyManua.ls Logo

Zodiac Z200 - User Manual

Zodiac Z200
10 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
H0469800_REVB - 2020/06
Noce Pièces Détachées / Accessoires - Français
Commande déportée
Instrucons originales
FR
Spare Parts/Accessories Instrucons Manual - English
Remote control
Translaon of the original instrucons in french
EN
IT
Manuale pezzi di ricambio/ Accessori -Italiano
Comando a Distanza
Traduzione delle istruzioni originali in francese
Manual Peças Sobresselentes/ Acessórios - Português
Comandos Remotos
Tradução das instruções originais em francês
PT
Aviso sobre piezas y accesorios - Español
Mando a distancia
Traducción de las instrucciones originales en francés
ES
Bedienungsanleitung für Ersatzteile / Zubehör - Deutsch
Fernsteuerungen
Übersetzung der Originalanleitung in französischer
Sprache
DE
Handleiding losse onderdelen / accessoires - Nederlands
Afstandsbediening
Vertaling van de originele Franse instruces
NL
Z200 / Z200 Defrost
PI20 / PI20 Defrost
JD PAC / JD PAC Defrost
Οδηγίες εγκατάστασης και λειτουργίας - Ελληνικά
Χειριστήριο απομακρυσμένης λειτουργίας
Μετάφραση των πρωτότυπων οδηγιών στα γαλλικά
EL

Other manuals for Zodiac Z200

Preview: Instructions For Installation
Instructions For Installation12 pages
Preview: Instructions For Installation And Use
Instructions For Installation And Use23 pages

Questions and Answers

  • K
    Karen FrederickJul 26, 2025
    What to do if my Zodiac Heat Pump is not working?
    • A
      anthony31Jul 26, 2025
      If your Zodiac Heat Pump is not working, first check the supply voltage and the F1 fuse. Also, the heat pump will stop heating if the setpoint temperature is reached, meaning the water temperature is at or above the setpoint. Ensure proper water flow; the heat pump will stop if the flow rate is insufficient. The unit will also stop if the outside temperature drops too low (below 5 °C for standard models or -5 °C for “Defrost” models). Finally, the heat pump might have detected an operating fault.
  • R
    Richard HillJul 30, 2025
    Why does my Zodiac Heat Pump trip the circuit breaker?
    • S
      Scott OconnellJul 30, 2025
      If your Zodiac Heat Pump is tripping the circuit breaker, verify that the circuit breaker is correctly sized and that the cable section used is the right one. Also, the supply voltage might be too low; in this case, contact your electricity supplier.
  • P
    petersondebraAug 4, 2025
    What to do if the evaporator is iced over on my Zodiac Heat Pump?
    • S
      Stephanie DillonAug 4, 2025
      If the evaporator of your Zodiac Heat Pump is iced over, the unit will soon switch to its defrost cycle to melt the ice. However, if the heat pump can't de-ice, it will stop, indicating the outdoor temperature is too low (below 5 °C for standard models or -5 °C for “Defrost” models).
  • M
    myersdebbieAug 8, 2025
    Why does my Zodiac Heat Pump not start heating immediately?
    • S
      silvayvonneAug 8, 2025
      If your Zodiac Heat Pump doesn't start heating right away, note that it remains paused for 5 minutes on start-up before beginning operation. Also, the heat pump stops heating once the setpoint temperature is reached, meaning the water temperature is at or above the setpoint. Ensure that water is circulating correctly and that hydraulic connections are properly done. The heat pump will also stop if the outdoor temperature falls below 5 °C for standard models or -5 °C for “Defrost” models. The heat pump may have detected an operating fault.
  • C
    Cindy JohnsonAug 12, 2025
    What to do if my Zodiac Heat Pump is working but the water temperature does not increase?
    • A
      ashleywhiteheadAug 12, 2025
      If your Zodiac Heat Pump is running but the water temperature isn't increasing, the heat pump may have detected an operating fault. Check that the automatic filling valve isn't stuck in the open position, as this will keep supplying cold water. Too much heat loss due to cool air can also prevent the temperature from rising, so install a heat-insulated cover on your pool. A dirty evaporator can also hinder performance, so clean it. Ensure the external environment isn't obstructing the heat pump and verify that the heat pump is the correct size for your pool and its environment.
  • J
    John MoralesAug 17, 2025
    Why is my Zodiac Heat Pump draining water?
    • T
      Theodore LynchAug 17, 2025
      If your Zodiac Heat Pump is draining water, this is often condensation, which is moisture in the air condensing on cold parts, especially the evaporator. To check if it's a pool circuit leak, shut down the heat pump, wait a few minutes, and run the filtration pump. If water continues to flow through the condensation drain, there's a leak; contact your reseller.
  • L
    Lisa CuevasAug 21, 2025
    Why does the compressor on my Zodiac Heat Pump stop intermittently when the ventilator is running?
    • J
      Jorge BaileyAug 21, 2025
      When the ventilator of your Zodiac Heat Pump is running but the compressor stops from time to time with no error message, the heat pump may be performing defrost cycles if the outdoor temperature is low. Also, the heat pump might not be capturing enough calories due to a dirty evaporator; clean it to restore performance.

Summary

General Safety Warnings

Professional Installation and Maintenance

Product must be installed and serviced by a qualified professional.

Electrical Shock Hazard

Turn off all switches and main breaker before installation.

Personal Protective Equipment (PPE)

Technicians must wear PPE to reduce injury risk.

Remote Control Compatibility

Remote Control Functionality

Remote control adjusts heat pump temperature.

WH000200 Compatible Models

Lists models compatible with WH000200 remote.

WH000476 Compatible Models

Lists models compatible with WH000476 remote.

Model Identification

Identify models by serial number on heat pump.

Display Indicator M42

M42 displayed on screen when switching on appliance.

Technical Specifications

Compatible Models (Defrost)

Lists specific Defrost model variants.

Model Serial Number Explanation

Explanation of serial number incrementation.

Display Indicator F42

F42 displayed on screen for defrost models.

Package Contents

Lists items included in the product package.

Installation Precautions

Cable Routing and Signal Integrity

Avoid routing signal cables with power cables.

Indoor Installation and Frost Protection

Appliance must be installed indoors, away from freezing.

Location Restrictions (Heat Sources)

Do not install near heat sources or chlorine-saturated air.

Mounting the Remote Control Unit

Steps for attaching the remote control case to a wall.

Physical Installation of Remote Control

Preparing the Heat Pump Housing

Drill a Ø 20 mm hole in the heat pump rear panel.

Connecting Cable to Board

Plug the cable into the remote control board.

Disconnecting Power

Ensure appliance is switched off before working.

Cable Management and Protection

Installing the Cable Gland

Screw the cable gland into the hole, ensuring correct orientation.

Using Cable Sheathing;Conduit

Lay the 20m cable in a sheath of Ø 20 mm minimum.

Connector Protection During Sheathing

Protect the connector when putting it into the sheath.

Wiring and Connections

Installing Mounting Clips

Install 4 clips below the heat pump board.

Attaching the Terminal Block

Clip the terminal block onto the installed clips.

Connecting to Terminal Block (Upper)

Connect cable from heat pump board to upper connector.

Connecting to Heat Pump Board (Middle)

Connect 30cm cable to middle connector and heat pump board.

Finalizing Installation and Operation

Connecting 20 m Cable (Bottom)

Connect the 20m cable to the bottom connector of the terminal block.

Cable Management in Raceways

Lay the cables in the designated raceways.

Immediate Operation and Display Duplication

Control is operational immediately, duplicating the heat pump display.

Keypad Locking Functionality

Locking function only affects the active keypad.

Remote Control Functions

Remote control functions are identical to the heat pump.

Wiring Diagram and Component Identification

Product Recycling Information

Information regarding the disposal and recycling of the appliance.

Zodiac Z200 Specifications

General IconGeneral
BrandZodiac
ModelZ200
CategoryHeat Pump
LanguageEnglish

Related product manuals