Zojirushi cv-dcc50 User Manual

QUICK TEMP MODE
This function heats the water to the selected Keep Warm temperature without reaching a boil. The water will reach the
selected Keep Warm temperature quicker than the regular Boil mode . Other benefits include reduced steam and
reduced energy use. Use this mode when dechlorination is not necessary, such as when using bottled or purified water.
While the water is heating,
press the ~~:~ button to select
the Quick Temp mode.
You cannot activate Quick Temp mode while
the product is set at 208°F Keep Warm mode
or Vacuum Insulation Keep Warm mode .
~
REBOIL ~
QUICKTEMP ~
/TEMP\ ~
\g!)IB
•You
cannot select 208°F Keep Warm mode or Vacuum Insulation Keep Warm mode while Quick Temp mode is activated .
•There
may be a lingering chlorine smell if tap water is used while Quick Temp mode is activated . If this is an issue , use the
regular Boil mode instead .
•Depending on the amount of water and room temperature the actual water temperature after heating may differ from that
shown on the Display .
•Depending on the amount of water, room temperature, and atmospher ic pressure, some steam may be produced .
•The
Quick Temp mode may be cancelled if the product is left unplugged for several minutes .
After reaching the
selected temperature, it
will automatically switch
to Keep Warm.
A melody sounds , the QUICK
TEMP light turns off and the KEEP
WARM ligh;rns on .
160°F Keep Warm
mode:
•once the water
temperature reaches
about 175°F (80°C) , it
will switch to Keep
Warm at 160°F (70°C) .
Length of time for the
water temperature to
reach 160°F after
heating up is approx .
1
hour.
eAfter the KEEP WARM
light stops blinking , it
will switch to Keep
Warm mode .
Each press of the REBOIUQUICK TEMP button changes the boil mode.
Regular Boil mode
(Default) t I
---+
*Holding the REBOIUQUICK TEMP button for more than 3 seconds
activates Ci tric Acid Cleaning mode. (see pg. 17)
M
41
M •] i :9
•water does not reach a boil under Quick Temp mode ,
and should not be used to prepare baby formula .
•Although the water will not reach a boil when
Quick Temp mode is activated, the Steam Vent
will become hot. Please do not touch it.
ENERGY-SAVING TIMER FUNCTION
The Boiling function will complete after the set time. (The Energy-Saving Timer Function helps save
energy by shutting off electricity to the heater until boiling begins.)
Press the 8 button until the desired length of time is displayed.
*
208 •
~◄ BH©I TIMER
175
160 lmllllMJ
Timer settings: (H for hours)
6H ➔ 7H ➔ 8H ➔ 9H ➔ 1 OH
t Cikleid§i I
*You will hear 2 beeps when 6H is selected .
A melody sounds and the Energy-
Saving Timer function is activated.
0
The Boiling function will complete
at the set time.
A melody sounds , the BOIL light turns off , and the
product switches to Keep Warm mode . (see pg . 9, 12 , 13)
Boiling may stop earlier than set , depending on room
temperature, water temperatu re and amount of water .
•~Mi ♦ ------------
•To cancel the Timer , press the TIMER button
several times or press the REBOIUQUICK TEMP
button once .
•when using the Qu i ck Temp mode wi th the
Energy-Saving Timer function , set the
Energy-Saving Timer function after selecting the
Quick Temp mode .
•1t the Power Cord is detached , the Energy-Saving
Timer function will be cancelled and must be
reset.
14

Zojirushi cv-dcc50 Specifications

General

Brand	Zojirushi
Model	cv-dcc50
Category	Boiler
Language	English