EasyManua.ls Logo

Zone Spark - Safe Operation Instructions

Default Icon
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
II. SAFE OPERATION INSTRUCTIONS
The low speed vehicle is designed for a simple operation; however, please make sure
to observe the following safe operation instructions:
BEFORE OPERATING THE VEHICLE:
ALWAYS read this first before you start driving the vehicle.
ONLY authorized people should drive this vehicle, from the driver’s side ONLY.
Drive the vehicle ONLY in areas where the vehicle is allowed by law or local
regulations and the conditions are safe to do so.
DO NOT allow more people on the vehicle than the vehicles’ designed capacity.
DO NOT overload the vehicle, otherwise, the motor may get damaged, and the
vehicle may lose control, putting the driver and passengers in danger.
DO NOT operate the vehicle while under the influence of alcohol or drugs.
DO NOT make the vehicle climb any slope beyond its grade ability.
DO NOT overtake other vehicles at crossroads, in blind areas, or in any
dangerous areas.
CHECK WITH YOUR LOCAL GOVERNING AUTHORITIES to ensure that
you remain in compliance with any laws, rules or regulations regarding the
operation of a Low Speed Vehicle. The Zone Spark meets FMVSS 500.517
(Federal Motor Vehicle Safety Standards for Low Speed Vehicles).
WHILE OPERATING THE VEHICLE:
Keep your entire body inside the vehicle, remain seated, buckle up with the seat
belts, and hold on while the vehicle is moving.
Do not start the vehicle until all occupants are securely seated and fastened set
belts.
Keep your hand on the steering wheel and your eyes on the path or road you are
travelling.
Always back up slowly and watch behind you carefully. Vehicle does make a
beeping noise while in reverse.