Need help?Do you have a question about the Zonefirst MINI-MASTERZONE MMP2 and is the answer not in the manual?
General| Zones | 2 |
|---|---|
| Thermostat Compatibility | Standard 24V thermostats |
| Input Voltage | 24 VAC |
| Output Voltage | 24 VAC |
| Weight | 1.5 lbs |
Details panel mounting, location selection, and wire management for the MMP2 system.
Covers factory settings and jumper configurations for HVAC equipment compatibility.
Explains 12VDC plug-in damper wiring, modular cords, and daisy-chaining limitations.
Guides on wiring single-stage thermostats to the MMP2 terminals.
Provides diagrams for connecting HVAC units and the necessary 24VAC transformer.
Describes the ZPS sensor, its function as a high/low limit, and wiring.
Explains how the MMP2 controls single-stage HVAC and zone dampers for heating/cooling.
Details the 2-minute purge mode for distributing conditioned air to satisfied zones.
Explains the intelligent timer managing transitions between heating and cooling modes.
Outlines system checkout using LED indicators and power application for verification.
Provides guidance on diagnosing issues using LED indicators and a Volt/Ohm meter.
Details how to check damper motor operation using DC voltage readings.
Addresses problems with zones not calling or not shutting off, including wiring.
To Next Page
