Dialer Installation & User’s Guide 1
Introduction
This dialer makes it easy for you to save money on phone
calls. It's easy to install and use, and works for all the phones
plugged into the same phone line as the dialer.
How the dialer works
The dialer simplifies using alternative long distance services
by automatically dialing the extra digits normally dialed by
hand. Some of these services, such as 1010 dial around
services, require you to dial some extra digits before dialing a
long distance number. Other services require you to dial an
access number, wait for a tone or a voice prompt, and then
dial a PIN. There would usually be another tone or voice
prompt, after which you would dial the number you wanted to
call. Then your call would be connected.
The dialer lets you dial normally, and then the dialer dials all
the right digits automatically. Once you've finished dialing,
you can hear the dialer dialing, and for some services you'll
also hear voice prompts. You just wait for the dialer to finish,
which is followed by the sounds you normally hear when you
make a call, such as a ringing signal, a busy signal, or
someone answering the call.
There is one other thing you should know about your dialer.
Before the dialer can work, it needs to be activated by your
service provider. The activation configures your dialer for
your location and calling plan. Your service provider will
activate your dialer by a remote download.
To Next Page
Loading...
