2 Dialer Installation & User’s Guide
Setting up and using the dialer involves
these easy steps:
1.
Install the dialer.
2.
Once the dialer is installed, make sure that the service
provider knows so he or she can call the dialer and load it
with information about routing your calls.
3.
If necessary, tailor the dialer to a special situation.
4.
Use the dialer.
1. Install the dialer
First find a suitable location for the dialer. This location needs
3 things:
i)
A standard phone jack connected to the phone line you
want to use for your dialer. It's okay if there's something
plugged into that jack, since the dialer has an extra jack
for that situation. (The dialer should not be used on a
phone line that has ADSL service for high-speed Internet
access.)
ii)
An electrical outlet near the phone jack for plugging in the
dialer's power cube. This power outlet should be powered
up all the time, and not be turned on or off by a light
switch.
iii)
The dialer's location should be as close to where the
phone line enters your premises as possible. See if you
can tell where the phone line comes into your premises,
and locate the dialer at the nearest phone jack if possible.
If you can't tell and you have an apartment, pick a jack
toward the center of the building. If you can't tell and you
have a home, pick a jack on or near the first floor if
possible.
Please see the picture on the next page. Plug the power cube
into the power outlet, and plug its other end into the dialer
power jack. The dialer's LED will blink rapidly ON and OFF. If
To Next Page
Loading...
