50
A setting program is available for the actuators (it is described in these Assembly Instructions); it enables
the parameters of the electronic outfit of the actuators to be set and checked by a computer.
The electronics is connected to the serial port of the computer by a cable (it is available e.g. under the name
“Extending cable for mouse 9F-9M”).
In case the computer is not fitted with a serial port the converter USB-RS 232, can be ordered.
Actuators fitted with electronics DMS2 ED
Part name
Part
Stock
Note
designation
item
Source board DMS2.ED.Z 39620000
Position sensor multi-revolution DMS2.ED.S 39620001
Torque sensor DMS2.TORK 39620003 common for DMS2.ED and DMS2
Analog module DMS.ED.CPT 39620004
back signal 4 – 20 mA and software
blocked regulator
Display DMS2.ED.D 39620005
Actuators fitted with electronics DMS2
Source board analog DMS2.ZAN 39620014 only for analog
Source board Profibus DMS2.ZPR 39620015 only for Profibus version
Position sensor multi-revolution DMS2.S 39620016
Torque sensor DMS2.TORK 39620003 common for DMS2.ED and DMS2
Display DMS2.DP 39620018
Board of local control block DMS2.H1 39620019
Dynamic brakes for actuators with electronics DMS2 ED a DMS2
Brake BR2 550 2339610124
Brake BR2 BK 550 2339610128
Brake BR 2,2 2339610142
Brake BR BK 2,2 2339610141
Braking resistance TR342 68R 2337110355
To Next Page
Loading...