1
2
6
5
4
3
7
Place ZB mount onto the gun picatinny rail and secure it by tightening two socket cap
screws (4) with allen key (supplied). Install the device that you are planning to zero onto
the top rail and secure it by picatinny type clamps, or by using countersunk bolts
(Universal model only).
Operate Elevation and Windage turrets (1) to zero the device. After zeroing is complete,
reset turrets to “0”. To do this, remove the screws (3) on both the turrets with a suitable
size coin or flat screwdriver, then remove the the turret cap and reinstall it back, making
sure that the “0” mark sits against the white line.
In unlikely event that more elevation adjustment is needed, this can be further increased
by rotating the elevation adjustment reset screw (5) clockwise. To do this you need to
unlock the screw by slacking the small grub screw (6) with an allen key (supplied). After
the adjustment is made, return the small grub screw into the locking position.
This mount does not have any serviceable part and does not require any special care,
but we recommend to keep it clean and dry.
1
2
3
4
5
6
7
Windage turret.
Elevation turret.
Unlocking grub screw.
Locking nuts.
Elevation adjustment reset.
Turrets resetting nuts.
Cavities for countersunk bolts*.
* universal model only
Thank you for purchasing precision, click adjustable
ZB mounts. To enjoy your mounts for many years
to come, please read the instructions carefully.
Please do not temper with any elements of this
mount that are not assigned in this manual as
operational.
zb-mounts.co.uk
To Next Page
Need help?
General
