Need help?Do you have a question about the ZT Lunchbox LBG2 and is the answer not in the manual?
Plug in your instrument here; accepts wide signal levels.
Controls input signal amount for overdrive and tone.
Adjusts the master volume output of the amplifier.
Adjusts bass and treble balance for desired sound.
Simulates natural reflections of an open-back cabinet.
Indicates amplifier power status.
Connect external speaker (min 8 Ohm) via 1/4 inch cable.
Controls output level for headphone/line out jack.
Stereo jack for headphones or line out to recording gear.
Toggles the internal 6.5 inch speaker on or off.
3.5mm stereo input for external audio sources.
Turns the amplifier on and off.
Protects from electrical faults; requires correct replacement type.
Connection point for the detachable AC power cable.
Sets mains voltage for compatibility with electrical systems.
All safety and operating instructions must be read and followed for safe use.
Details input impedance (>1MΩ) and internal speaker size (6.5 inch).
Lists physical dimensions, weight (9.5 lbs), and SPL (>120dB).
Specifies total output power (200 watts) and voltage (115V/230V selectable).
Summarizes controls on the top and rear panels.
Provides steps for resolving no power, no sound, and noisy signal problems.
Information on how to contact ZT Amplifiers for technical support.
Instructions for obtaining service and repair within and outside the USA.
Details the one-year warranty against defects in parts and workmanship.
Explains how to transfer the warranty and conditions that void it.
Outlines steps for obtaining warranty service, including RMA number.
States ZT Amplifiers' liability limitations for damages.
General| Technology | Solid State |
|---|---|
| Number of Channels | 1 |
| Impedance | 8 ohms |
| EQ Controls | Tone |
| Controls | Volume, Tone |
| Power Source | AC Power |
| Type | Guitar Amplifier |
| Inputs | 1 x 1/4" |
To Next Page
