6
1. ENTERING THE PROGRAMMING MODE
1).Switch your Transmitter ON and set the throttle stick to its maximum position.
2).Connect the battery pack to the ESC
3).Wait for about 2 seconds until you hear two short beeps (● ● ● ● ● ● ● ● ) confirming
that the ESC has now entered the programming mode.
2. SELECTING THE PROGRAMMABLE ITEM
The Programming Mode is in Sequence, each Programmable Item is equivalent to an
audible tone emitting for four times. You will hear 10 tones in a loop with the following
sequence. When the desired tone for the Programmable Item is reached, move the
throttle stick down to its minimum position. The motor will emit one special tone
confirming the desired programmable item has been entered.
3. SELECTING THE DESIRED VALUE OF THE PROGRAMMABLE ITEM
The motor has been emitting sequentially. If the desired value of the programmable item
is reached, set the throttle stick to its maximum position. The motor will emit one
special tone confirming the new setting has been stored.
4. DISCONNECTING THE BATTERY PACK.
If you don't want to go on to programming, disconnect the battery pack directly. If you
want to go on to programming, keep waiting to the next programmable item to select the
value you need.
Note: You could also select the LED program card to program your desired function.
Program card is as the option spare part, its programming procedure is described in the
LED program card user manual.
THE TONES WILL BE HEARD IN SEQUENCE AS FOLLOWS:
1 Beep- Brake Type (1 short tone)
2 Beep-Beep- Battery Type (2 short tone)
3 Beep-Beep-Beep- Cut off Voltage Threshold (3 short tone)
4 Beep-Beep-Beep-Beep- Restore Factory Setup Defaults (4 short tones)
5 Beep----- Motor Timing (1 long tone)
6 Beep-----Beep- SBEC Voltage Output (1 long tone 1 short tone)
7 Beep-----Beep- Beep- Governor Mode (1 long tone 2 short tone)
8 Beep-----Beep- Beep- Beep- Motor Rotation (1 long tone 3 short tone)
9 Beep-----Beep- Beep- Beep- Beep- Start up Strength (1 long tone 4 short tone)
10 Beep----- Beep----- Low Voltage Cut off Type (2 long tone)
To Next Page
Loading...
Need help?
General