Need help?Do you have a question about the ZUCCHETTI AZZURRO 1PH HYD3000-HYD6000-ZSS-HP and is the answer not in the manual?
General| Category | Inverter |
|---|---|
| Model | AZZURRO 1PH HYD3000-HYD6000-ZSS-HP |
| Brand | ZUCCHETTI |
| Type | Hybrid Inverter |
| Number of MPPTs | 2 |
| Nominal AC Voltage | 230 V |
| Max. Efficiency | 97.6% |
| Protection Degree | IP65 |
| Output Voltage | 230 V |
| Frequency | 50/60 Hz |
| Efficiency | 97.6% |
| Battery Voltage | 48 V |
| Operating Temperature | -25°C to +60°C |
| Cooling | Natural Convection |
| Max PV Input Power | 6000W |
| Max. AC Power | HYD6000-ZSS-HP: 6 kW |
| Max. Output Current | HYD6000-ZSS-HP: 26 A |
| Output Power | HYD6000-ZSS-HP: 6 kW |
| Communication | RS485, WiFi |
| Protection | Overvoltage, Overcurrent, Short Circuit |
| Humidity | 0% - 95% non-condensing |
Important safety precautions must be followed during installation and maintenance of the equipment.
Describes the assembly, installation, electrical connections, commissioning, maintenance and troubleshooting.
Intended for qualified technical personnel and system operators responsible for installation and startup.
Electrical installation and maintenance must be done by qualified electricians according to national regulations.
Battery protection, ventilation, avoiding sunlight/heat, and safe handling procedures are detailed.
Explains safety symbols like hazard, electric shock, high voltage, hot surfaces, CE, ground, and IP rating.
Inverter inspection before packaging, no upside-down handling, check packaging and accessories.
Lists all components and accessories included in the package.
Specifies requirements for installation location: dry, clean, ventilated, temperature, humidity, and altitude.
Lists necessary tools for installation, including drill, screwdriver, stripper, and multimeter.
Guides on vertical mounting for heat dissipation and protection from direct sunlight.
Step-by-step guide for mounting the bracket, positioning the inverter, and grounding.
Details recommended cable types and specifications for battery, PV, load, and grid connections.
Instructions for connecting protective ground cables (PGND) with procedure steps.
Explains grid connection with residual current monitoring and AC circuit breaker requirements.
How to connect critical loads for Emergency Power Supply (EPS) mode.
Recommended specifications for DC input cables and connection procedure.
Covers general battery connection and specific types like Pylontech, WeCo, and AZZURRO.
Explains the function of the Back, Up, Down, and OK buttons for navigation.
Details the meaning of grid active, off-grid, and alarm indicator lights.
Checks for secure attachment, cable connections, polarity, and AC switch status before operation.
Guides on initial startup, checking AC switch, and supplying DC power correctly.
Covers main menu navigation, basic and advanced settings, and software updates.
Reviews device settings in system information for correct parameters like country code and PV input mode.
Instructions for cleaning the inverter using a compressor or soft cloth, avoiding water/chemicals.
Instructions for cleaning the heat sink using a compressor or soft cloth, avoiding water/chemicals.
Steps to disconnect inverter, remove connectors, and detach from the wall.
Recommends packing the inverter in its original packaging if possible.
Guidelines for storing the inverter in a dry place within a specific temperature range.
Information on proper disposal of the product according to local regulations.
Installation, configuration, and troubleshooting for the external Wi-Fi adapter.
Installation, check, and troubleshooting for the Ethernet adapter.
Installation and check procedures for the 4G adapter.
Preliminary notes, electrical connections, configuration, and monitoring for datalogger devices.
Mechanical description, connections, internet configuration, and local monitoring for datalogger devices.
To Next Page
