ZURN Aquaflush Z6000 Series User Manual (English)

Questions and Answers:

C
claireevansAug 13, 2025
Why is my ZURN Aquaflush Z6000 Plumbing Product valve flushing too long or not shutting off?
- S
  salasanthonyAug 13, 2025
  If your ZURN Plumbing Product's valve flushes too long or doesn't shut off, it could be due to several reasons. Foreign material might be preventing the trip mechanism from seating properly; try disassembling the parts and rinsing them thoroughly. The by-pass orifice could be plugged; examine it and clean carefully without enlarging the opening. Inadequate line pressure could also be the issue; take steps to increase the line pressure. Finally, a cracked cover might be the cause; replace it with a new one.
M
Meredith BookerAug 17, 2025
What to do if my ZURN Aquaflush Z6000 Plumbing Product valve is short flushing?
- D
  Danielle BarrettAug 17, 2025
  If your ZURN Plumbing Product valve is short flushing, it could be due to the diaphragm kit not being matched to the fixture. To solve this, install the proper P6000-EUR or P6000-ECR replacement kit. Another potential cause is a urinal trip mechanism being installed in a closet flush valve. If this is the case, install a closet trip mechanism (white #12).
P
Paul Myers Jr.Aug 21, 2025
Why does my ZURN Aquaflush Z6000 have insufficient water volume to adequately siphon the fixture?
- A
  Alexa HillAug 21, 2025
  If your ZURN Plumbing Product has an insufficient water volume to adequately siphon the fixture, the stop valve may not be open enough; open it for the desired water volume. Alternatively, a urinal trip mechanism might be incorrectly installed; replace it with the proper closet valve part. Insufficient volume or pressure at the supply could also be the cause. If you cannot measure supply pressure or water volume, remove the working parts and open the stop valve to allow water to pass through the empty valve. If the supply is adequate, you may remove the guide ring (#16) from the guide assembly to provide additional flow. If this doesn't work, take steps to increase the pressure and/or supply.
E
Edward HamiltonAug 25, 2025
How to fix a ZURN Aquaflush Z6000 flush valve that shuts off too quickly?
- J
  jennifermunozAug 25, 2025
  If the flush valve of your ZURN Plumbing Product shuts off too quickly, it may be due to a damaged or punctured diaphragm, or an enlarged by-pass orifice. In either case, install a new P6000-EUR or P6000-ECR replacement kit to remedy the problem.
C
Carla PriceAug 28, 2025
How to make my ZURN Aquaflush Z6000 Plumbing Product flush quieter?
- A
  aharrisAug 28, 2025
  If the flush of your ZURN Plumbing Product is not quiet, the control stop may not be adjusted for quiet operation; adjust it while considering the fixture evacuation requirements. The fixture itself or the piping system could also be contributing to the noise. To check the fixture, place a cover over the bowl opening to separate valve noise from bowl noise. If the fixture is too noisy, consult with the fixture manufacturer. High pressure in the system can sometimes be controlled by the stop valve. Other sources of noise may be the absence of air chambers and shock arrestors, loose pipes, or improper pipe sizes. In these cases, the building engineer should be consulted.
B
Brian FlemingAug 31, 2025
Why is water splashing out of my ZURN Aquaflush Z6000 fixture?
- D
  Debbie RoseSep 1, 2025
  If water splashes out of the fixture with your ZURN Plumbing Product, it could be due to the supply volume being more than necessary; adjust the control stop downward. Alternatively, lime accumulation on the vortex or spreader holes of the fixture might be the cause; remove the lime build-up.
C
Casey NguyenSep 4, 2025
How to troubleshoot a ZURN Plumbing Product valve that will not operate?
- T
  Tanya MolinaSep 4, 2025
  If your ZURN Plumbing Product valve will not operate, it could be because the stop valve or the supply valve is closed. Open the stop valve and the supply valve to resolve this issue.
Z
Zachary WatsonSep 8, 2025
What to do if my ZURN Aquaflush Z6000 Plumbing Product handle assembly is leaking?
- M
  Matthew RangelSep 8, 2025
  If the handle assembly of your ZURN Plumbing Product is leaking, it is likely not tight. Try tightening the handle assembly to resolve the leak.

ZURN Aquaflush Z6000 Series Specifications

General

Category	Plumbing Product
Type	Flush Valve
Model	Z6000 Series
Valve Body Material	Brass
Finish	Polished Chrome
Warranty	3-Year Limited Warranty
Water Conservation	Yes
Outlet Connection	1-1/2" IPS
Material	Brass
Flush Volume	1.6 GPF (Gallons Per Flush)
Power Source	Hardwired or Battery

Summary

ZURN Aquaflush Flushometer Manual

Product Specification and Options

Details product specifications, models, flows, and options.

Installation Instructions

Step-by-step guide for installing Aquaflush flush valves.

Exposed Repair Kits

Lists available repair kits and part numbers for Aquaflush products.

Trouble Shooting Guide

Addresses common problems and solutions for Aquaflush flush valves.

ZURN EZ Flush Automatic Sensor Retrofit Kit Manual

Description and Components

Details the E-Z Flush system's description and components.

Installation Guide

Step-by-step instructions for installing the E-Z Flush kit.

Activation and Adjustment

Covers activating and adjusting the E-Z Flush system.

Troubleshooting Guide

Addresses common problems and solutions for the E-Z Flush system.

ZURN AquaSense Lavatory Faucet Manual

Installation Steps

Provides detailed steps for installing AquaSense faucets.

Repair Kits

Lists part numbers for Z6913-XL and Z6915-XL faucet repair.

Specifications and Operation

Outlines product specifications, operation, and care instructions.

JUST Manufacturing Sink Warranty Information

Residential Sink Warranty

Details lifetime warranty for residential sinks.

Commercial Sinks and Faucets Warranty

Details warranty for commercial sinks and faucets.

Obtaining Warranty Service

Instructions on how to obtain warranty service for sinks.

ZURN TEMP-GARD Faucet Manual

Troubleshooting Faucet Issues

Addresses common problems with TEMP-GARD faucets.

Faucet Installation and Maintenance

Explains installation and maintenance procedures for TEMP-GARD faucets.

Murdock Water Cooler Manual

Limited Warranty

Outlines warranty terms for Murdock water coolers.

Roughing-In and Dimensional Drawing

Provides installation dimensions and rough-in requirements.

Installation and Start Up

Guides for installing and starting up the water cooler.

Pipe Installation Types

Details pipe installation for different water cooler configurations.

Re-Piping Instructions

Steps for re-piping from non-pressurized to pressurized systems.

Troubleshooting Guide

Addresses common problems and solutions for water coolers.

Cartridge Replacement and Strainer Maintenance

Instructions for maintaining the cartridge and strainer.

Cooler Parts Breakdown

Lists and identifies all cooler parts.

Electric Residential Water Heater Manual

Safety Information and Warnings

Covers general safety, warnings, and precautions.

Water Temperature Setting

Details how to set and adjust water heater temperature.

Installing the Water Heater

Guidance on location, regulations, and inspection.

Thermal Expansion and Water Supply

Addresses thermal expansion and water supply connections.

Relief Valve and Filling Instructions

Information on relief valve installation and filling the tank.

Electrical Connections and Wiring

Details electrical requirements and wiring diagrams.

Energy Efficiency and Insulation

Covers energy efficiency measures and insulation.

Installation Checklist

A checklist for proper water heater installation.

Operating the Water Heater

Guidance on safe operation and safety controls.

Care and Cleaning

Instructions for draining, maintenance, and cleaning.

Troubleshooting Tips

Helps identify and resolve common water heater problems.

Replacement Parts

Information on ordering replacement parts.

Cavity Insert Instructions

Instructions for servicing cavity inserts.

If You Need Service

Guidance on how to obtain service for the water heater.

Grundfos Maintenance-Free Circulators

Shipment Inspection and Pre-Installation Checklist

Steps for inspecting components before installation.

Pump Usage and Specifications

Details pump applications and maximum operating parameters.

Installation and Pump Mounting

Guidance on installing and mounting the circulator pump.

Electrical Connections

Information on proper electrical grounding and wiring.

Start-Up and Operation

Procedures for starting up and operating the circulator pump.

Failure to Operate

Troubleshooting common operational failures.

Limited Warranty

Details the warranty terms for Grundfos circulators.

Liberty Pumps OilTector Manual

Introduction and Safety Guidelines

Overview of the OilTector system and safety precautions.

Description of Operation

Explains how the OilTector system operates.

Installation of Control Panel

Steps for mounting and wiring the OilTector control panel.

Installation of Preset Level Sensor Holder

Guidance on installing the level sensor holder.

Installation of Remote Alarm Unit

Steps for installing the OilTector remote alarm unit.

Testing the System

Procedures for testing the complete OilTector system.

Maintenance

Instructions for cleaning and maintaining the OilTector.

Trouble Shooting

Addresses common problems and solutions for the OilTector.

Related product manuals

ZURN AquaSense ZTR Series

16 pages

ZURN AquaSense Z6920 Series

4 pages

ZURN AquaSense ZTR6200-WS1-DF

16 pages

ZURN AquaSense Z6920-XL Series

4 pages

PlumbSmart AquaSense Z6913-XL Series

28 pages

ZURN ZSHIELD Z1072

2 pages

ZURN Light Commercial Z1996

2 pages

ZURN Z1300 Ecolotrol

4 pages

ZURN HYDRO-X Power Serio Series

12 pages

ZURN Aquaflush Z6000 Series User Manual

Table of Contents

Questions and Answers:

ZURN Aquaflush Z6000 Series Specifications

Summary

ZURN Aquaflush Flushometer Manual

Product Specification and Options

Installation Instructions

Exposed Repair Kits

Trouble Shooting Guide

ZURN EZ Flush Automatic Sensor Retrofit Kit Manual

Description and Components

Installation Guide

Activation and Adjustment

Troubleshooting Guide

ZURN AquaSense Lavatory Faucet Manual

Installation Steps

Repair Kits

Specifications and Operation

JUST Manufacturing Sink Warranty Information

Residential Sink Warranty

Commercial Sinks and Faucets Warranty

Obtaining Warranty Service

ZURN TEMP-GARD Faucet Manual

Troubleshooting Faucet Issues

Faucet Installation and Maintenance

Murdock Water Cooler Manual

Limited Warranty

Roughing-In and Dimensional Drawing

Installation and Start Up

Pipe Installation Types

Re-Piping Instructions

Troubleshooting Guide

Cartridge Replacement and Strainer Maintenance

Cooler Parts Breakdown

Electric Residential Water Heater Manual

Safety Information and Warnings

Water Temperature Setting

Installing the Water Heater

Thermal Expansion and Water Supply

Relief Valve and Filling Instructions

Electrical Connections and Wiring

Energy Efficiency and Insulation

Installation Checklist

Operating the Water Heater

Care and Cleaning

Troubleshooting Tips

Replacement Parts

Cavity Insert Instructions

If You Need Service

Grundfos Maintenance-Free Circulators

Shipment Inspection and Pre-Installation Checklist

Pump Usage and Specifications

Installation and Pump Mounting

Electrical Connections

Start-Up and Operation

Failure to Operate

Limited Warranty

Liberty Pumps OilTector Manual

Introduction and Safety Guidelines

Description of Operation

Installation of Control Panel

Installation of Preset Level Sensor Holder

Installation of Remote Alarm Unit

Testing the System

Maintenance

Trouble Shooting

Related product manuals