With the use of the above equipment will achieve through the App,
please go to Google Play or App Store to download and install.
In addition to the equipment listed above, a telescope, camera,
tripod, power supply, etc. are required to fully assemble and start
shooting. This guide does not cover the work of these devices, you
can refer to their instruction documents.
二、Detailed Settings
* By default, you have assembled the hardware part of the device.
2.1 Switch ASIAIR WiFi Band
ASIAIR uses 5G band WiFi by default, while AZ-GTi Mount uses
2.4G, so you need to switch the ASIAIR WiFi band to 2.4G. Open the
ASIAIR App,
Press to switch to 2.4G.
ASIAIR WiFi SSID is
ASIAIR_Dev.Fei
which will be used later.
2.2 AZ-GTi Mount WiFi Settings
Connect your mobile devices to AZ-GTi Mount’s WiFi, the SSID is
SynScan
, you needn’t to input password because it’s an open
network.
After connecting (e.g. with
iPhoneX iOS 12.0.1
):
To Next Page
Need help?
General
