Chapter 6 Tutorials
GS1200 Series User’s Guide
28
2 Enter 2 in the VLAN ID field for the VLAN2 network.
3 Since the VLAN2 network is connected to port 1 on the Switch, configure port 1 to be a permanent
member of the VLAN. To ensure that VLAN-unaware devices (such as computers and hubs) can receive
frames properly, click the port’s box color to green to set the Switch to remove VLAN tags before
sending. Clicking the port’s check box loops between untagging, non-member, and tagging.
4 Change the box color of other ports not a member of the VLAN group to gray.
5 Click Apply to save the settings.
To Next Page
Loading...
