Chapter 30 Link Aggregation
GS1920v2 Series User’s Guide
163
Figure 110 PORT > Link Aggregation > Link Aggregation Status
The following table describes the labels in this screen.
Table 74 PORT > Link Aggregation > Link Aggregation Status
LABEL DESCRIPTION
Group ID This field displays the group ID to identify a trunk group, that is, one logical link containing multiple
ports.
Enabled Ports These are the ports you have configured in the Link Aggregation Setting screen to be in the trunk
group.
The port numbers displays only when this trunk group is activated and there is a port belonging to
this group.
Synchronized
Ports
These are the ports that are currently transmitting data as one logical link in this trunk group.
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number.
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
Criteria This shows the outgoing traffic distribution algorithm types used in this trunk group. Sending of
packets are from the same source and/or to the same destination over the same link within the
trunk.
src-mac means the Switch distributes traffic based on the packet’s source MAC address.
dst-mac means the Switch distributes traffic based on the packet’s destination MAC address.
src-dst-mac means the Switch distributes traffic based on a combination of the packet’s source
and destination MAC addresses.
src-ip means the Switch distributes traffic based on the packet’s source IP address.
dst-ip means the Switch distributes traffic based on the packet’s destination IP address.
src-dst-ip means the Switch distributes traffic based on a combination of the packet’s source
and destination IP addresses.
Note: To find the number of link aggregation algorithm types that can link up at the
same time, see Algorithm Types Limitation on page 162.
Status This field displays how these ports were added to the trunk group. It displays:
• Static – if the ports are configured as static members of a trunk group.
• LACP – if the ports are configured to join a trunk group through LACP.
To Next Page
Loading...
