Chapter 39 Multicast
GS1920v2 Series User’s Guide
244
Figure 172 MVR Configuration Example
To configure the MVR settings on the Switch, click the Add/Edit button in the SWITCHING > Multicast >
MVR screen. Create a multicast VLAN and set the receiver and source ports.
Figure 173 MVR Configuration Example
To set the Switch to forward the multicast group traffic to the subscribers, click Add/Edit in the
SWITCHING > Multicast > MVR > Group Setup screen and configure multicast group settings. The
following figure shows an example where two IPv4 multicast groups (News and Movie) are configured
for the multicast VLAN 200.
To Next Page
Loading...
