Chapter 59 Policy Rule
GS1920v2 Series User’s Guide
376
Figure 273 SECURITY > ACL > Policy Rule > Add/Edit
The following table describes the labels in this screen.
Table 211 SECURITY > ACL > Policy Rule > Add/Edit
LABEL DESCRIPTION
Source & Destination
Active Enable the switch button to enable the policy.
Name Enter a descriptive name for identification purposes. You can enter up to 32 printable ASCII
characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Classifier(s) This field displays the active classifiers you configure in the SECURITY > ACL > Classifier >
Classifier Setup screen.
Select the classifiers to which this policy rule applies. To select more than one classifier, press
[SHIFT] and select the choices at the same time.
General Parameters
Set the fields below for this policy. You only have to set the fields that is related to the actions you configure in the
Action field.
Vlan ID Specify a VLAN ID.
Egress Port Enter the number of an outgoing port.
Priority Specify a priority level.
TOS Specify the Type Of Service (TOS) priority level.
To Next Page
Loading...
