Chapter 4 Web Configurator
GS1920v2 Series User’s Guide
63
NETWORKING
ARP Setup Click the link to unfold the following sub-link menu.
ARP
Learning
This link takes you to a screen where you can configure ARP learning mode on a per-port basis.
DHCP Click the link to unfold the following sub-link menu.
DHCPv4
Relay
This link takes you to screens where you can view DHCPv4 relay status, mode, and configure
DHCPv4 relay settings.
DHCPv6
Relay
This link takes you to a screen where you can enable and configure DHCPv6 relay.
Static Routing Click the link to unfold the following sub-link menu.
IPv4 Static
Route
This link takes you to a screen where you can configure IPv4 static routes. A static route defines
how the Switch should forward traffic by destination IP address and subnet mask.
SECURITY
AAA Click the link to unfold the following sub-link menu.
RADIUS
Server
Setup
This link takes you to a screen where you can configure your RADIUS (Remote Authentication Dial-
In User Service) server settings for authentication.
TACACS+
Server
Setup
This link takes you to a screen where you can configure your TACACS+ (Terminal Access Control-
ler Access Control System Plus) server settings for authentication.
AAA Setup This link takes you to a screen where you can configure authentication, authorization and
accounting services through external servers. The external servers can be either RADIUS or
TACACS+ (Terminal Access Controller Access Control System Plus).
Access Control Click the link to unfold the following sub-link menu.
Service
Access
Control
This link takes you to a screen where you can decide what services you may use to access the
Switch.
Remote
Managem
ent
This link takes you to a screen where you can specify a group of one or more “trusted computers”
from which an administrator may use a service to manage the Switch.
Account
Security
This link takes you to a screen where you can configure account security settings on the Switch.
ACL Click the link to unfold the following sub-link menu.
Classifier This link takes you to screens where you can configure the Switch to group packets based on the
specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform special treatment
on the grouped packets.
Storm Control This link takes you to a screen to set up broadcast filters.
Errdisable This link takes you to a screens where you can view errdisable status and configure errdisable set-
tings in CPU protection, errdisable detect, and errdisable recovery.
IPv4 Source
Guard
Click the link to unfold the following sub-link menu.
IP Source
Guard
This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
DHCP
Snooping
This link takes you to screens where you can view DHCP snooping database details and configure
DHCP snooping settings on ports or VLANs. You can use DHCP snooping to filter unauthorized
DHCP packets on the network and to build the binding table dynamically.
ARP
Inspection
This link takes you to screens where you can view ARP inspection status, and configure ARP
inspection settings on ports or VLANs. You can use ARP inspection to filter unauthorized ARP pack-
ets on the network.
Table 11 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
