ENGLISH
9
1. In the following screen, check the Status of your NSA210. If it shows
Up, you can start using your NSA210. If it shows Uninitialized, click
the Config icon to start initialization.
2. Input your settings in the Network Configuration screen.
• Select DHCP if you have a network device (such as a router or
cable modem) that assigns IP addresses to clients. This
automatically selects Dynamic DNS.
• Select Static IP if the clients in your network have specific address
assignments. This automatically selects Static DNS. Enter the
details in corresponding fields (IP Address, IP Subnet Mask,
Gateway Address, Primary DNS and Secondary DNS.) You can
also click Copy from NSU to have the NAS Starter Utility detect
and fill in these values.
To Next Page
Loading...
