If you know the AC-IP, you can also write the IP directly via console.
Figure 72 Tera Term > AP > Router > configure terminal > capwap ap ac-ip
<AC-IP1> <AC-IP2> > write > exit > rebot
Note: If there is only one controller in the topology, write the controller’s IP in
the <AC-IP1> and p
ut any IP in t
he <AC-I
P2>.
4 Can managed AP and NXC communicate with each other?
Access managed AP and NXC by console or SSH and ping to each other to
check the status of network traffic.
Managed AP ping to controller successfully:
Figure 73
Tera Term > AP >
Router > ping <AC-
IP>
Controller ping managed AP successfully:
Figure 74 Tera Term > NXC > Router > ping <AP-IP>
Ping loss
If the managed AP or controller pings to each other fail, you have to check
the Ethernet device or network cable.
Figure 75 Tera Term > NXC > Router > ping <AP-IP>
To Next Page
Loading...
