answer mode on-line. Whenever your modem establishes a connection
with another modem, one of the modems must be in answer mode and
the other modem must be in originate mode or a connection is not
possible.
Equivalent AT commands:
+++ Escape sequence code; causes a modem to return to command
mode. Enter escape sequence in data state and wait for the modem
to respond.
ATH On-hook; disconnect the modem.
ATD Originate on-line.
ATA Answer on-line.
REPEAT LAST DIAL
Access `R' (Repeat last dial) by pressing the left or right arrow
key and the ENTER key. Before a connection is made, any key
pressed from the front panel or terminal keyboard will abort the
redial operation.
Equivalent AT commands:
ATDL Repeat last dial.
A/ Repeat last command once.
A> Repeat last command once, retry the last call up to 9
(depending on the country) times.
AUTO ANSWER
Move to the STATUS REGISTER menu, and change the S0 value to the
number of rings until the modem will automatically answer. A
value of zero disables auto answer.
Equivalent AT commands:
ATS0=0 Disable auto-answer.
ATS0=n Auto answer on n rings.
DIALING MESSAGE
Dialing from the terminal or front panel will cause the following
screen to be displayed on the LCD.
((MODE-13))
Dialed phone number will be displayed on the second line of the
20 X 2 LCD screen. If the number exceeds 20 digits, only the
first 20 digits/characters will be displayed. If the phone jack
is not plugged in or not attached, the LCD screen will display
the following:
To Next Page
Loading...
