Fax Operation 53
Command Value Description
n=3 9600 bps.
n=4 12000 bps.
n=5 14400 bps.
+FPHCTO=
<value>
0-255 DTE Phase C response time-out:
Determine how long the DCE will wait
for a command after reaching the end
of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
+FPTS=n Page transfer status
n=1 Received page good.
n=2 Page bad; retrain requested.
n=3 Page good; retrain requested.
n=4 Page bad; procedure interrupt
requested.
n=5 Page good; procedure interrupt
requested.
+FREL=n Phase C received EOL alignment:
n=0 The EOL patterns are bit aligned as
received.
n=1 The last received bits of EOL patterns
are byte aligned by the DCE, with
necessary zero fill bits inserted. Refer
to TIA PN-2388 for details.
+FREV? Request the DCE revision
identification.
+FSPL=n "Enable polling" command:
n=0 Disable polling.
n=1 Enable polling.
All other +F commands are not supported, but the modem will
respond OK. In many cases this means "don't care." See PN 2388
for command details.
Class 2 Command Responses
To Next Page
Loading...
