Chapter 16 Firmware Upgrade
WX Series User’s Guide
156
Figure 79 Firmware Uploading
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, the following screen will appear. Click OK to go back to the Firmware
Upgrade screen.
Figure 80 Error Message
Note that the WX Device automatically restarts during the upload, causing a temporary network
disconnect. In some operating systems, you may see the following icon on your desktop.
Network Temporarily Disconnected
Current
Firmware
Version
This is the present Firmware version and the date created.
File Path Enter the location of the file you want to upload in this field or click Browse/Choose File to find it.
Browse/
Choose File
Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to two minutes.
Table 47 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
To Next Page
Loading...
