Chapter 2 Hardware
WX Series User’s Guide
23
Link (With a
WiFi
connection)
Green On The WiFi connection to the MPro Mesh router is good.
Red On The signal is too weak. Move the WX Device closer to the MPro
Mesh Router.
Link (With a
wired
connection)
Green On The Ethernet cable is connected to the LAN port on the WX
Device.
WiFi Green On The 2.4G / 5G WiFi is ready.
Blinking The WX Device is transmitting/receiving WiFi data.
Off The 2.4G / 5G WiFi is disabled.
WPS Amber On This indicates the WX Device is the controller.
Blinking If you press the WPS button, amber blinking within 120 seconds
means the WPS is in process.
Off The WPS process is done.
Table 5 LED Table (for WX Device-2)
LED COLOR STATUS DESCRIPTION
POWER
Green On Power is on or MPro Mesh pairing is done.
Blinking The WX Device-2 is starting up or the MPro Mesh pairing is in
process.
Red On The WX Device-2 detects a system error.
Blinking The WX Device-2 is upgrading firmware or the MPro Mesh pairing
has failed.
Link (with a
WiFi
connection)
Green On The WiFi connection to the WX Device-1 is good.
Red On The signal is too weak. Move the WX Device-2 closer to the WX
Device-1.
Link (with a
wired
connection)
Green On The Ethernet cable is connected to the LAN port on the WX
Device-2.
WiFi Green On The 2.4 G / 5 G WiFi is ready.
Blinking The WX Device-2 is transmitting/receiving WiFi data.
Off The 2.4 G / 5 G WiFi is disabled.
WPS Amber Blinking If you press the WPS button, amber blinking within 120 seconds
means the WPS is in process.
Off The WPS process is done.
Table 4 LED Table (for WX Device-1) (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
