2N Access Unit - Page 100

1002N TELEKOMUNIKACE a.s., www.2n.cz
®
RFID Card Reader Module 13.56 MHz
The 13.56 MHz RFID Card Reader ( ) is one of the Part No. 9155033 2N
®
Access
elements and is used for reading RFID card Ids in the 13.56 MHz band.Unit
The module contains two bus connectors.2N
®
Access Unit
These two connectors are fully interchangeable and can be used both as inputs
from the basic unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains
unconnected.
The module package includes a 220 mm long interconnecting cable.
The following RFID cards can be read:
ISO14443A
Mifare Classic 1k & 4k, DESFire EV1, Mini, Plus S&X, SmartMX, Ultralight,
Ultralight C, SLE44R35, my-d move (SLE66Rxx), PayPass, Legic Advant
ISO14443B
Calypso, CEPAS, Moneo, SRI512, SRT512, SRI4K, SRIX4K, PicoPass, HID
iCLASS
I/O Module
The I/O module ( ) is one of the elements and isPart No. 9155034 2N
®
Access Unit
used for extending of the number of inputs and outputs.
The module contains two bus connectors.2N
®
Access Unit
These two connectors are fully interchangeable and can be used both as inputs
from the basic unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains
unconnected.
The module package includes an 80 mm long interconnecting cable.
The inputs / outputs are addressed as follows:
, e.g. module5.relay1. Configure the<module_name>.<input/output_name>
module name in the Module name parameter in the Hardware / Extenders menu.