Installation Completion
Check the connection of all wires and the RJ-45 plug to the board connector.
Name tag Placing
Every intercom package includes a piece of transparent foil, which can be laser printed.
Cut the printed foil and insert the name tags in the buttons.
We recommend you to put a name tag in every button in the 5-button module. Refer to
for the name tag printing template.www.2n.cz
Name tag dimensions for 5-button module:
1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; - 0.5 mm)
5 buttons: 57.5 (W) x 89.0 (H) mm (dimensional tolerance: +0; - 0.5 mm)
Infopanel name tag dimensions: 69.2 (W) x 86.7 (H) mm (dimensional tolerance: +0;
- 0.5 mm).
Name tag inserting/replacing:
Remove the frame.
Lift up the button door. The 5-button module buttons have just one door.
Remove the used name tag and insert a new one.
Close the button door.
Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A
Screw the flush mounting frame in the upper and bottom parts.
Caution
Make sure that the terminals of all the unused connectors are tightened
properly to avoid sound vibrations.
Caution
The area where name tags are placed is called a wet zone. After heavy
rain, water can penetrate to the name tag. Water in this area does not
affect the intercom functionality in any way and evaporates soon.
Always use waterproof foil (enclosed or other) for the name tags. Never
use paper or ink jet printing to avoid damage due to water leakage!
To Next Page
Loading...
