15
Checking Unit Connections
When you have connected all your units, power on the
units and the Switch. The Port Status LEDs for the ports you
have used on both the units and the Switch should be on. If
they are not, check your connections and the settings of the
Uplink/Normal switches.
Figure 4
Correct Connections for an OfficeConnect Hub
Spot Checks
At frequent intervals, visually check that:
■
The Alert LED is off — this is the best way to find out if
there are problems with your network.
■
Case vents are not obstructed.
■
Cabling is secure and not pulled taut.
Switch set to
Uplink (in)
OfficeConnect
Switch
OfficeConnect
Hub
Twisted pair cable
with RJ-45 connectors.
Maximum length is
100m (328ft)
Uplink/Normal
Uplink/Normal
3C16734_Booklet.book Page 15 Tuesday, July 13, 1999 11:05 AM
To Next Page
Loading...
