Manual Setup
37
Figure 9 Example top-level command line interface menu
3 At the Select menu option prompt enter the protocol ip
basicConfig command. At the Enter configuration method
prompt enter manual. The screen prompts you to enter IP information.
4 Enter the IP address, subnet mask, and gateway IP address for the Switch.
The screen displays a summary of the information entered.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See “Methods of
Managing a Switch” on page 41.
If you do not intend to use the command line interface via the console
port to manage the Switch, you can disconnect the serial cable and close
the terminal emulator software.
DUA1720-3AAA03_online.book Page 37 Monday, March 25, 2002 10:48 AM
To Next Page
Loading...