3Com 5500-SI - Page 17

3Com Switch 5500 Family 17
Quick Reference Guide
display logbuffer
Use the display logbuffer command to display the status of the log buffer and the records in the log
buffer.
Any view
display loopback-detection
Use the display loopback-detection command to display whether loopback detection function is enabled
or not.
Any view
display mac-address
Use the display mac-address command to display MAC address table information.
Any view
display mac-address aging-time
Use the display mac-address aging-time command to display the aging time of the dynamic entry in the
MAC address table.
Any view
display mac-address multicast static
Use the display mac-address multicast static command to display the multicast MAC address entries
manually configured on the switch, with each entry containing the following information: multicast MAC
address, VLAN ID, MAC address state, port number(s), and aging time of each port.
Any view
display mac-authentication
Use the display mac-authentication command to display the global information about centralized MAC
address authentication, including the state of centralized MAC address authentication (enabled or
disabled), values of centralized MAC address authentication timers, the number of online users, MAC
addresses during quiet period, and MAC authentication information about each port.
Any view
display memory
Use the display memory command to view the memory setting.
Any view
display memory
Use the display memory command to display the current system memory status.
Any view
display memory limit
Use the display memory limit command to display the memory setting and state information related to
the Ethernet switch capacity, including available memory and state information about connections, such as
times for disconnecting connections, times for reestablishing connections, and the current state of the
system.
Any view
display mirror
Use the display mirror command to view port mirroring configuration, including monitored ports, monitor
port and monitor direction, and so on.
Any view
display mirroring-group
Use the display mirroring-group command to display the parameter settings of a port mirroring group.
Any view
display mpm
The display mpm command displays information about the multicast port management parameters.
Any view
display msdp brief
Use the display msdp brief command to display the brief information of the MSDP peer state.
Any view
display msdp peer-status
Use the display msdp peer-status command to display the detailed information of the MSDP peer state.
Any view
display msdp sa-cache
Use the display msdp sa-cache command to display (S, G) state learned from an MSDP peer.
Any view
display msdp sa-count
Use the display msdp sa-count command to display the number of sources and groups in MSDP cache.
Any view