3Com 5500-SI - Page 3

3Com Switch 5500 Family 3
Quick Reference Guide
acl
Use the acl command to reference ACL and implement the ACL control to the TELNET users.
User Interface view
acl
Use the acl command to define an ACL identified by a number, and enter the corresponding ACL View.
System view
active region-configuration
Use the active region-configuration command to activate the settings of an MST (multiple spanning
tree) region.
MST Region view
add-member
Use the add-member command to add a candidate device to a cluster.
Cluster view
address-check
Use the address-check command to enable or disable DHCP relay security on a VLAN interface, so as to
start the validity check on user addresses under the VLAN interface.
VLAN Interface view
administrator-address
Use the administrator-address command to store the MAC address of the management device on a
member device.
Cluster view
am enable
Use the am enable command to enable address management IP address pool.
System view
am ip-pool
Use the am ip-pool command to set an address management IP address pool for a port, permitting the
packets in this IP address pool whose IP addresses are the source IP addresses to pass the port for layer
3 forwarding.
Ethernet Port view
am trap enable
Use the am trap enable command to enable the access management trap function.
System view
am user-bind
Use the am user-bind command to bind the MAC address and IP address of a legal user to the specified
port.
System view
Ethernet Port view
apply cost
Use the apply cost command to configure the route cost value of route information.
Route Policy view
apply poe-profile
Use the apply poe-profile command to apply the existing PoE Profile configuration to the specified
Ethernet port.
System view
apply qos-profile
Use the apply qos-profile command to apply the QoS profile to the current port.
Ethernet Port view
apply qos-profile interface
Use the apply qos-profile interface command to apply a QoS profile to one or more consecutive ports.
System view
apply tag
Use the apply tag command to configure to set the tag area of OSPF route information.
Route Policy view
area
Use the area command to enter an OSPF area view.
OSPF view