3Com 5500-SI - Page 4

3Com Switch 5500 Family
Quick Reference Guide
arp check enable
Use the arp check enable command to enable the checking of an ARP entry so the device does not learn
the ARP entry where the MAC address is a multicast MAC address.
System view
arp static
Use the arp static command to manually configure the static ARP mapping entries in the ARP mapping
table.
Ethernet Port view
arp static
Use the arp static command to manually configure the static ARP mapping entries in the ARP mapping
table.
System view
arp timer
Use the arp timer aging command to configure the dynamic ARP aging timer.
System view
asbr-summary
Use the asbr-summary command to configure a summary of imported routes for OSPF.
OSPF view
ascii
Use the ascii command to configure data transmission mode as ASCII mode.
FTP Client view
attribute
Use the attribute command to configure some attributes for specified local user.
Local User view
authentication
Use the authentication command to configure an authentication scheme for the current ISP domain.
ISP Domain view
authentication-mode
Use the command authentication-mode to configure login authentication.
User Interface view
authentication-mode
Use the authentication-mode command to configure an OSPF area to use a specified authentication
mode.
OSPF Area view
authorization
Use the authorization none command to allow users in the current ISP domain to use network services
without being authorized.
ISP Domain view
auto-build
Use the auto-build command to configure a cluster automatically.
Cluster view
auto-execute command
Enter auto-execute command text to configure the Switch to automatically run a specified command.
User Interface view
backup current-configuration to
Use the backup current-configuration to command to back up either all configurations or the current
configuration of a specified switch to a file on a TFTP server.
User view
binary
Use the binary command to configure file transmission type as binary mode.
FTP Client view
boot attribute-switch
Use the boot attribute-switch command to toggle between the main and backup attributes of file.
User view
boot boot-loader
Use the boot boot-loader command to assign the main attribute to an App file on one switch or all switches
in the fabric, so as to use this App file as the preferred boot file upon next startup of switch.
User view