3Com Baseline 2226 Plus Release Note

BASELINE SWITCH 2226 PLUS FIRMWARE
VERSION 1.0.0.6 RELEASE NOTES
Legal Rights
IMPORTANT: READ THIS BEFORE INSTALLING OR USING
THIS SOFTWARE
You should carefully read the terms and conditions of
the Software License Agreement. This text is contained
in a file called license.txt. Your legal rights are defined
therein.
USE OF THIS SOFTWARE INDICATES THAT YOU ACCEPT
SUCH TERMS AND CONDITIONS. IF YOU DO NOT
AGREE WITH SUCH TERMS AND CONDITIONS, DO NOT
USE THIS SOFTWARE.
Related Documentation
Use these notes in conjunction with the 3Com Baseline
Switch 2226 Plus User Guide (part number
DUA16475B-SAAA01), which is supplied with your
Switch. A PDF version of this guide is also available for
download on the 3Com Web site at www.3com.com.
You can obtain the latest technical information about
your Switch, including a list of known problems and
solutions, from the 3Com Knowledgebase:
http://knowledgebase.3com.com
Enhancement in This Release
Installing this firmware version adds the Device Mimic to
the Web interface. The Device Mimic, shown in
Figure 1, is an image of the Switch's front panel that
indicates ports that are currently in use. When you place
the cursor on an active port, a text block will pop up
and show the current status of this port.
You can also click a port on the Device Mimic to go to
the Port Configuration screen of the Web interface.
Figure 1 Device Mimic
Voyager3_RN.fm Page 1 Friday, July 1, 2005 5:28 PM

3Com Baseline 2226 Plus Specifications

General

Switching Capacity	8.8 Gbps
Forwarding Rate	6.6 Mpps
VLAN Support	Yes
MAC Address Table Size	8K entries
Operating Temperature	0°C to 40°C
Operating Humidity	10% to 90% non-condensing
Ports	24 x 10/100
Management	Web-based
Status Indicators	Link/Activity
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3x, IEEE 802.1p, IEEE 802.1Q
Power Supply	Internal power supply