AAA and RADIUS Protocol Configuration 275
When using scheme radius-scheme radius-scheme-name local in the
configuraton command, the local refers to the alternative authentication scheme if
the RADIUS server does not respond normally. Therefore, when RADIUS server
operates normally, the local scheme is not used. Otherwise, the local scheme is
used. When using
scheme radius-scheme radius-scheme-name (without local),
the local scheme does not work when there is no normal response.
You can use either scheme or radius-scheme command to specify the RADIUS
scheme for an ISP domain. If both of these two commands are used, the latest
configuration will take effect.
Configuring ISP Domain State
Every ISP has active/block states. If an ISP domain is in active state, the users in it
can request for network service, while in block state, its users cannot request for
any network service, which will not affect the users already online.
Tab le 303 Configuring ISP Domain State
By default, after an ISP domain is created, the state of the domain is active.
Setting Access Limit
Maximum number of users specifies how many users can be contained in the ISP.
For any ISP domain, there is no limit to the number of users by default.
Tab le 304 Setting Access Limit
By default, there is no limit to the amount of users.
Enabling/Disabling the Idle-Cut Function
The idle cut function means if the traffic from a certain connection is lower than
the defined traffic, this connection is cut off.
Tab le 305 Enabling/Disabling the Idle-cut Function
By default, the idle-cut function is disabled.
Enabling the Selection of the RADIUS Accounting Option
If no RADIUS server is available or if the RADIUS accounting server fails when the
accounting optional is configured, the user can still use the network resource,
otherwise, the user will be disconnected. The user configured with the
accounting optional command in RADIUS scheme will no longer send real-time
accounting update packets or offline accounting packets.
Operation Command
Specify the ISP domain state to be active state active
Specify the ISP domain state to be block state block
Operation Command
Set a limit to the amount of users access-limit { disable | enable
max_user_number
}
Restore the limit to the default setting undo access-limit
Operation Command
Set the idle idle-cut enable
minute flow
Disable the idle-cut function idle-cut disable
To Next Page