MAC Address Table Management 309
Tab le 354 Set the Max Count of MAC Address Learned by a Port
By default, there is no limit to the MAC addresses learned via the Ethernet port.
Displaying MAC Address
Tab le
After the above configuration, execute the display command in all views to
display the running of the MAC address table configuration, and to verify the
effect of the configuration.
Execute the debugging command in User View to debug MAC address table
configuration.
Tab le 355 Display and Debug MAC Address Table
MAC Address Table
Management Display
Example
Networking requirements
The user logs into the switch via the Console port to display the MAC address
table. Switch display the entire MAC address table of the the switch. If this switch
is a member of a stack then the entire database of all the switches will be shown
here.
Operation Command
Set the Max Count of MAC Address
Learned by a Port
mac-address max-mac-count
count
Restore the default Max Count of MAC
Address Learned by a Port
undo mac-address max-mac-count
Operation Command
Display the information in the
address table
display mac-address [
mac-addr
[ vlan
vlan-id
] | [ static | dynamic | blackhole
] [ interface {
interface-name
|
interface-type interface-num
} ] [ vlan
vlan-id
] [ count ] ]
Display the aging time of dynamic
address table entries
display mac-address aging-time
To Next Page