320 CHAPTER 12: FILE SYSTEM MANAGEMENT
■ Configure the Test Parameter
Enable HWPing Client By enabling HWPing client, various types of tests can be set and carried out.
Perform the following configurations in System View.
Table 370 Enable HWPing Client
By default, HWPing Client is disabled.
Creating a Test Group HWPing test group is a set of HWPing test items. Each test group includes several
test items and is uniquely identified by an administrator name plus an operation
tag.
You may perform HWPing test after creating a test group and configuring all the
parameters.
Perform the following configurations in System View.
Table 371 Create a Test Group
By default, no test group is configured.
Configure the Test
Parameter
The following parameters are included in an HWPing test group:
■ Destination address
■ Test t ype
■ Number of packets sent for a test
■ Packet transmission interval
■ Test timeout time
Configuring a Destination Address
The Destination address is equal to the destination address in a ping command.
Perform the following configurations in HWPing Test Group View.
Table 372 Configuring a Destination Address
By default, no destination address is configured.
Operation Command
Enable HWPing client hwping-agent enable
Disable HWPing client undo hwping-agent enabled
Operation Command
Create a test group hwping
administrator-name operation-tag
Remove the test group undo hwping
administrator-name operation-tag
Operation Command
Configure a destination address destination-ip
ip-address
Delete the destination address undo destination-ip
To Next Page