HWPing 321
Configuring a Test Type
You can test various connections by using the HWPing function. You can only
configure one test type at a time.
Currently, the system only supports ICMP test.
Perform the following configuration in HWPing Test Group View.
Tab le 373 Configure a Test Type
By default, test type is set to ICMP.
Configure the Number of Messages Sent for a Test
If the number of messages sent for a test is set to greater than 1, the system sends
the second message (after the first message has been sent) upon
acknowledgement of the first message or upon the expiration of the test timer if
no acknowledgement is received. This continues until all the test messages have
been sent as configured. The parameter discussed in this subsection is equal to the
parameter
-n in a ping command.
Perform the following configurations in HWPing Test Group View.
Tab le 374 Configure the Number of Messages sent for a Test
By default, one message is sent for a test.
Configuring Auto-Test Interval
Configured with the auto-test feature, the system will automatically test the
connection of a specified type at regular intervals.
Perform the following configurations in HWPing Test Group View.
Tab le 375 Configure Auto-Test Interval
By default, auto-test interval is set to 0, i.e. only one test is performed.
Configuring Test Timeout Time
Test timeout time refers to the period that the system waits for ECHO-RESPONSE
after sending an ECHO-REQUEST message. If the message expires, the system will
Operation Command
Configure a test type test-type
type
Operation Command
Configure the number of messages sent
for a test
count
times
Restore the default number of message
sent for a test
undo count
times
Operation Command
Configure an auto-test interval frequency
interval
Disable auto-test undo frequency
To Next Page