322 CHAPTER 12: FILE SYSTEM MANAGEMENT
regard the destination unreachable. The parameter discussed in this subsection is
equal to the parameter
-t in a ping command, except in a different time unit.
Perform the following configurations in HWPing Test Group View.
Table 376 Configure a Test Timeout Time
By default, test timeout time is set to three seconds.
Executing Test After creating a test group and configuring the required test parameters, you can
perform an HWPing test in the test group by executing the
test-enable
command.
Perform the following configuration in HWPing Test Group View.
Table 377 Test
After you execute the test-enable command, the system does not display the
test result. You may view the test result information by executing the display
hwping
command.
Displaying Test
Information
You may view the test history and the last test information respectively by
executing
display hwping history and display hwping result commands.
Perform the following operations in any view.
Table 378 Display the Test Information
Operation Command
Configure a test timeout time timeout
time
Restore the default setting of test timeout
time
undo timeout
Operation Command
Execute test
test-enable
Operation Command
Display the test information display hwping
{
history | result
}
[
administer-name operation-tag
]
To Next Page