328 CHAPTER 12: FILE SYSTEM MANAGEMENT
■ The output language can be selected between Chinese and English.
1 Sending the information to loghost.
Table 382 Sending the Information to Loghost
2 Sending the information to the control terminal.
Table 383 Sending the Information to the Control Terminal.
3 Sending the Information to monitor terminal
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center
is enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information
output direction to
loghost
- The configuration about the loghost
on the Switch and that on loghost
must be the same; otherwise the
information cannot be sent to the
loghost correctly.
Set information
source
- You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding module
before defining output debugging
information.
Loghost Refer to
configuration cases
for related log host
configuration
- -
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default, info-center
is enabled.
Other configurations are valid
only if the info-center is
enabled.
Set the information output
direction to Console
- -
Set information source - You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on. You
must turn on the Switch of
the corresponding module
before defining output
debugging information.
Enable terminal display
function
- You can view debugging
information after enabling
terminal display function
To Next Page