Logging Function 329
Tab le 384 Sending the Information to Monitor Terminal
4 Sending the Information to log buffer.
Tab le 385 Sending the Information to Log Buffer
5 Sending the Information to trap buffer.
Tab le 386 Sending the Information to Trap Buffer
6 Sending the Information to SNMP
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default,
info-center is
enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information
output direction to
monitor
- -
Set information
source
- You can define which modules and
information to be sent out and the
time-stamp format of information, and
so on. You must turn on the Switch of
the corresponding module before
defining output debugging
information.
Enable the terminal
display function and
this function for the
corresponding
information
- For Telnet terminal and dumb terminal,
to view the information, you must
enable the current terminal display
function using the terminal
monitor command.
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information output
direction to logbuffer
- You can configure the size of the
log buffer at the same time.
Set information source - You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the Switch of the
corresponding module before
defining output debugging
information.
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default, info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to
trapbuffer
You can configure the size of
the trap buffer at the same time.
Set information source You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
To Next Page