330 CHAPTER 12: FILE SYSTEM MANAGEMENT
Table 387 Sending the Information to SNMP
7 Turn on/off the information synchronization Switch in Fabric
Figure 83 Turn on/off the Information Synchronization Switch in Fabric
Sending the Information
to Loghost
To send information to the loghost, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 388 Enable/Disable Info-Center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to loghost
Perform the following operation in System View.
Device Configuration Default value Configuration description
Switch
Enable info-center By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is
enabled.
Set the information output
direction to SNMP
- -
Set information source - You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
Configuring SNMP features - See SNMP Configuration
Network
management
workstation
The same as the SNMP
configuration of the Switch
- -
Device Configuration Default Value
Configuration
Description
Switch
Enable info-center By default, info-center is
enabled.
Other configurations are
valid only if the
info-center is enabled.
Set the information
output direction to
SNMP
By default, Switches of master
log in Fabric, debugging and trap
information synchronization are
turned on, so as log and strap
information synchronization
Switches in other Switches.
This configuration can
keep log information,
debugging information
and trap information in
Fabric in every Switch
synchronized.
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
To Next Page