Logging Function 331
Tab le 389 Configuring to Output Information to Loghost
Ensure to enter the correct IP address using the info-center loghost command
to configure loghost IP address. If you enter a loopback address, the system
prompts of invalid address appears.
3 Configuring the information source on the Switch
With this command, you can define the information that is sent to the control
terminal, such as: generated by which modules, information type, information
level, and so on.
Perform the following operation in System View.
Figure 84 Defining Information Source
modu-name
specifies the module name; default represents all the modules; level
refers to the severity levels;
severity
specifies the severity level of information.
The information with the level below it will not be output.
channel-number
specifies the channel number and
channel-name
specifies the channel name.
When defining the information sent to the loghost,
channel-number
or
channel-name
must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select debugging as the information type when configuring information
source, meantime using the
debugging command to turn on the debugging
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View:
Tab le 390 Configuring the Output Format of Time-stamp
Operation Command
Output information to loghost info-center loghost
host-ip-addr
[
channel { c
hannel-number
|
channel-name
}
| facility
local-number
| language {
chinese | english } ]
Cancel the configuration of
outputting information to loghost
undo info-center loghost
host-ip-addr
Operation Command
Define information source info-center source {
modu-name
| default }
channel {
channel-number
|
channel-name
} [ {
log | trap | debug }* { level
severity
|
state
state
}* ]
Cancel the configuration of
information source
undo info-center source {
modu-name
| default
} channel {
channel-number
|
channel-name
}
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
To Next Page