332 CHAPTER 12: FILE SYSTEM MANAGEMENT
4 Configuring loghost
The configuration on the loghost must be the same with that on the Switch. For
related configuration, see the configuration examples in the latter part of this
chapter.
Sending the Information
to Control Terminal
To send information to the control terminal, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 391 Enable/disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in System View.
Table 392 Configuring the Output Information to Control Terminal
3 Configuring the information source on the Switch.
With this configuration, you can define the information sent to the control
terminal that is generated by which modules, information type, information level,
and so on.
Perform the following operation in System View:
Table 393 Defining Information Source
modu-name
specifies the module name; default represents all the modules; level
refers to the severity levels;
severity
specifies the severity level of information.
The information with the level below it will not be output.
channel-number
specifies the channel number and
channel-name
specifies the channel name.
Output time-stamp is disabled undo info-center timestamp { log |
trap | debugging }
Operation Command
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Operation Command
Output information to Console info-center console channel{
channel-number
|
channel-name
}
Cancel the configuration of
outputting information to Console
undo info-center console channel
Operation Command
Define information source info-center source {
modu-name
| default }
channel {
channel-number
|
channel-name
} [ {
log | trap | debug }* { level
severity
|
state
state
}* ]
Cancel the configuration of
information source
undo info-center source {
modu-name
| default
} channel {
channel-number
|
channel-name
}
To Next Page