48 CHAPTER 2: PORT OPERATION
■ Setting the Description Character String for the Ethernet Port
■ Setting the Duplex Attribute of the Ethernet Port
■ Setting Speed on the Ethernet Port
■ Setting the Cable Type for the Ethernet Port
■ Enabling/Disabling Flow Control for the Ethernet Port
■ Permitting/Forbidding Jumbo Frames to Pass through an Ethernet Port
■ Setting the Ethernet Port Suppression Ratio
■ Setting the Link Type for an Ethernet Port
■ Adding an Ethernet Port to Specified VLANs
■ Setting the Default VLAN ID for the Ethernet Port
■ Setting Loopback Detection for an Ethernet Port
■ Copying Port Configuration to Other Ports
Entering Ethernet Port View
Before configuring an Ethernet port, enter Ethernet Port View.
Perform the following configuration in System View.
Enabling/Disabling an Ethernet Port
Use the following command to disable or enable the port. After configuring the
related parameters and protocol of the port, you can use the following command
to enable the port. If you do not want a port to forward data, use the command
to disable it.
Perform the following configuration in Ethernet Port View.
By default, the port is enabled.
Setting the Description Character String for the Ethernet Port
To distinguish the Ethernet ports, use the following command to assign a
description to each port.
Perform the following configuration in Ethernet Port View.
Table 30 Entering Ethernet Port View
Operation Command
Enter Ethernet Port View interface {
interface_type
interface_num
|
interface_name
}
Table 31 Enabling/Disabling an Ethernet Port
Operation Command
Disable an Ethernet port shutdown
Enable an Ethernet port undo shutdown
Table 32 Setting the Description Character String for the Ethernet Port
Operation Command
Set description character string for Ethernet port. description
text
To Next Page
Loading...
