3. In the X-Y-Z fields, the post-navigation positions are displayed but you can enter any values. Click the Go to button to send the unit to the required
position.
4. Click the related button to use the Gripper for either single or double-wide slide. Depending on which the active button is, click the Open/Close
button to set the Gripper to the defined value.
5. The Home button navigates the Slide loader 3D unit to zero position on all axes.
Keyboard control:
The components can be navigated using the keyboard, too. Some functionalities have their related buttons. Using a keyboard is useful when
the operator must physically approach P1000 as much as software operation is not adequate. It is recommended to use a wireless keyboard for
such operations. The volume + an – buttons of some keyboards can be used to adjust resolution, too.
To Next Page
Loading...
