3M 3M-Matic 800r3 - Specifications; Power and Operating Requirements; Tape Specifications

7
1. Power Requirements:
Electrical  115 VAC, 60 Hz, 3.8 A (440 watts)
Pneumatic  6.5 bar gauge pressure [95 PSIG]
110 litre/min @ 21° C, 1.01 bar
[3.75 SCFM] at 15 boxes per
minute
The machine is equipped with two 1/6 HP
gearmotors and comes with a 2.4 meter [8 ft]
long standard neoprene covered power cord
and a grounded plug. Contact your 3M
Representative for power requirements not
listed above.
2. Operating Rate:
Up to 15 boxes per minute. Actual production
rate is dependent on box size, box size mix, and
operator dexterity.
Box drive belt speed is 24 m/m [78 FPM]
3. Operating Conditions:
Use in dry, relatively clean environments at 4° to
50° C [40° to 120° F] with clean, dry, boxes.
Note  Machine should not be washed down or
subjected to conditions causing moisture
condensation on components.
4. Tape:
Scotch
TM
brand pressure-sensitive film box
sealing tapes.
5. Tape Width:
48 mm [2.0 in] minimum to
72 mm [3.0 in] maximum
6. Tape Roll Diameter:
Up to 405 mm [16.0 in] maximum on a
76.2 mm [3.0 in] diameter core.
(Accommodates all system roll lengths of
Scotch
TM
brand film tapes.)
7. Tape Application Leg Length  Standard:
70 mm ± 6 mm [2.75 in ±.25 in]
Tape Application Leg Length  Optional:
(See "Special Set-Up Procedure", page 24)
50 mm ± 6 mm [2.00 in ±.25 in]
8. Box Board:
Style  regular slotted containers  RSC
125 to 275 P.S.I. bursting test, single wall or
double wall B or C flute.
(Specifi cations continued on next page)
4-SPECIFICATIONS
1. Power Requirements
Electrical: 115 Volt,60Hz, 3.8 A (440 watts)
The machine is equipped with a 2.4m [8 foot] standard neoprene covered power cord and a grounded plug.
Contact your 3M Representative for power requirements not listed above.
2. Operating Rate
Box drive belt speed is approximately 0.5 m/s [100 feet per minute].
5. Tape Width
36mm [1 1/2 inch] minimum to 50mm [2 inch] maximum
4. Tape
Scotch
®
pressure-sensitive fi lm box sealing tapes.
3. Operating Conditions
Use in dry, relatively clean environments at 5
o
C to 50
o
C [40
o
F to 120
o
F] with clean, dry boxes.
Note: Machine should not be washed or subjected to conditions causing moisture condensation on
components.
0
5
10
15
20
25
30
35
40
45
0 5 10 15 20 25 30 35 40
Pneumatic – 5 bar gauge pressure [70 PSIG] 110 litre/min @ 21 C, 1.01 bar [3.75 SCFM] at 15 boxes per
minute A pressure regulator is included
• To reduce the risk associated with fi re
and explosion hazards:
− Do not operate this equipment in poten-
tially fl ammable or explosive environments.
WARNING