19
Recommended Spare Parts
Listed are a set of spare parts that will periodically require replacement due to normal wear. These parts should
be ordered to keep the taping heads in production:
AccuGlide™ 3 Upper Taping Head - 3 Inch
Qty. Ref. No. Part Number Description
4 10932-22 78-8076-4500-3 Stud – Mounting
1 10928-10 78-8137-3311-6 Spring – Upper Extension
1 10928-2 78-8028-7899-7 Knife – 89mm/3.5 Inch
2 10928-12 78-8052-6602-6 Spring – Cutter
1 - 78-8076-4726-4 Tool – Tape Threading
AccuGlide™ 3 Lower Taping Head - 3 Inch
Qty. Ref. No. Part Number Description
1 10928-2 78-8028-7899-7 Knife – 89mm/3.5 Inch
2 10928-12 78-8052-6602-6 Spring – Cutter
4 10931-22 78-8076-4500-3 Stud – Mounting
1 10927-10 78-8137-3312-4 Spring – Lower Extension
1 - 78-8076-4726-4 Tool – Tape Threading
In addition to the above set of spare parts supplied with the taping head, it is suggested that the following spare
parts be maintained which will require replacement under normal wear of the taping head.
Qty. Ref. No. Part Number Description
1 10929-15 78-8057-6181-0 Roller – Applying
1 10926/10927-5 78-8057-6180-2 Roller – Buffi ng
1 10928-18 78-8113-7030-9 Spring – Torsion
Replacement Parts and Service
Refer to the fi rst page of this instruction manual “Replacement Parts and Service Information."
Spare Parts/Service Information
AccuGlide 3 Taping Head - 3"
2009 February
To Next Page
Loading...