4
Important Safeguards (Continued)
The "Stop" label, shown in Figure 1-4, is located in
front of the E-Stop switch and reminds operators
and casual personnel of the function of this switch.
In addition, an "On/Off" label is attached next to the
On/Off switch on the left machine guard at the
infeed end.
Figure 1-4 Stop and On/Off Labels
The "Safety Instructions" label, shown in
Figure 1-6, is attached to the frame next to the air
valve/regulator and reminds operator of correct air
pressure to use. The "On/Off" label reminds
operators of the location of the pneumatic On/Off
valve.
Figure 1-6 Safety Instructions Label
The "Safety Instructions" label, shown in
Figure 1-5, is attached to the front of the upper
assembly. The label provides convenient safeguard
instructions for the operator and service personnel.
Figure 1-5 Safety Instructions Label
Two "Operating Notice" labels, shown in
Figure 1-7, are located on the top, infeed end of
both drive belt assemblies. The labels remind
operators of correct belt adjustment procedures.
Figure 1-7 Operating Notice Label
To Next Page
Loading...