3M 7700 Series - Cable Preparation Steps; Step 1: Set Blade Depth; Step 2: Cut Cable Length; Step 3: Align and Lock Cable

Steps
3M
™
Round Conductor Flat, Controlled Impedance Cable, 7700 Series
Cable Preparation Instructions | 78-9102-5431-3 Rev A
Figure 12
Figure 10
Figure 7Figure 6
Figure 8 Figure 9
Figure 11
Step 3
Align the cut portion of cable against the right angle guide on the upgraded
Carpenter Model 47 Cable Stripper. Push forward to make contact with the

Step 9
Trim excess covering using a
precision utility knife for clearance
when terminating to 3M
™
Ribbon
Cable Wiremount Socket Assembly,
451 Series, optional.
Step 4
Slice blades closed using

Step 5
Rotate
covering.
Step 6
Reset
then 1 to starting positions.
Step 7
Remove sample from
upgraded Carpenter
Model 47 Cable Stripper
and carefully peel off any
remaining foil covering,
as necessary.
Step 8
Inspect sample specimen
for covering removal and
insulation damage.
Step 1
Set blade depth on the
upgraded Carpenter
Model 47. See page 1
“Set blade depth”
for details.
Step 2
Cut 3M cable 7700 series
to the appropriate length,
using any ribbon cable
cutter.